Adhesive instructions sticker

Allow the (wall) sticker to acclimatize for 1 day
If you have the wall sticker at home, you naturally want it to look nice on the wall. Therefore, read these adhesive instructions carefully!
Preparation in advance:

- Unroll the wall sticker well before you start. This prevents the sticker from rolling together.

- Do not keep the sticker for longer than a few weeks, otherwise the adhesive power will be reduced. A vinyl wall sticker consists of 3 parts. - Surface on which the sticker is placed

- The sticker itself

- An application layer (transparent). This ensures that you can stick the sticker on in one go.

Make sure you remove the layers according to the adhesive instructions.

Surface preparations:
Before you stick the wall sticker, the surface must be dry and free of grease. If the wall has just been painted, only apply the sticker once the paint has hardened properly. If you want the wall sticker in a different order than on the sheet, you can cut it loose and place it how you want the sticker. We recommend sticking the large wall stickers on the wall with two people.

Step 1:
Place the sticker flat on the table with the application layer facing up. Now rub this layer well on the sticker because when the back sheet is removed, all parts of the sticker will have to be on the application layer. It is therefore important that you press the small parts of the sticker properly. This can be done, for example, with a tea towel, squeegee or bank card.

Step 2 (large wall sticker):
Place the wall sticker with a piece of painter's tape where you want it. Do this in the middle of the wall sticker and then from top to bottom. Carefully fold one side over and remove the base. Make sure that no stickers remain on the surface. Then cut the substrate away from the loose half.

Step 2 (small stickers):
With small wall stickers you can immediately remove the surface. Do this carefully and make sure that no pieces of the sticker remain on the surface. It is important that the sticker rests on the application tape when the surface the sticker is on is removed. So everything has to go to the application layer.

Step 3:
Now stick the sticker evenly on the wall. Do this from the inside out. Press the sticker firmly with a squeegee or a bank card. For the large wall sticker, repeat this on the other side.

Step 4:
Allow the wall sticker with the application layer to work for an hour.

Step 5:
After an hour, carefully remove the application layer along the wall. Now only the sticker remains on the wall. Be careful not to pull off any pieces of the sticker, do this gradually and carefully. It is important that you pull the application layer away from the wall and not towards you. If you have any questions, please feel free to contact us